Guide · Businesses · 4 min read · Updated 17 November 2026
HIAB or Mobile Crane for a Generator Lift? A Plain Guide
Short answer
A HIAB lorry is usually enough for portable and canopied generators up to around 200–500kVA when the drop point is close to where the lorry can park. A mobile crane is needed for containerised sets, long reaches over walls or buildings, and heavy sets in awkward positions. HIAB delivery costs £350–£1,200 depending on size, while a separate mobile crane lift costs £600–£1,800.
What a HIAB is
HIAB is the name commonly used for a lorry-loader crane: a hydraulic knuckle-boom crane mounted on a rigid lorry behind the cab or at the rear. The lorry carries the generator and lifts it off itself, so one vehicle and one trained operator can deliver and place a set in a single visit. That makes it the cheapest way to move most canopied generators.
Lorry-loader cranes come in a wide range of sizes. A small one may lift a few tonnes close in, while the largest can handle much heavier loads with extensions and jibs. What matters for your job is the capacity at the radius needed, not the headline figure.
When a mobile crane is needed
A mobile crane is a separate vehicle, usually an all-terrain or city crane with a telescopic boom, brought to site purely for the lift. It has far greater capacity at long radius than a lorry-mounted crane, which is why it is used to lift heavy sets over buildings, onto roofs or into enclosed yards.
The generator arrives on a flatbed or step frame and the crane lifts it off and places it. This adds a second vehicle and crew, and on larger jobs a crane supervisor and slinger signaller, so the cost rises. For containerised generators, a mobile crane is almost always the right choice.
| Situation | Likely method | Guide price |
|---|---|---|
| Canopied 60–200kVA, short reach | HIAB lorry | £350–£700 |
| Canopied 200–500kVA, open site | Larger HIAB or crane-assisted | £600–£1,200 |
| Containerised set | Flatbed plus mobile crane | from £900 plus crane |
| Lift over a building or onto a roof | Mobile crane | £600–£1,800 for the lift |
| Basement or internal plant room | Rigging and skating | from £1,500 |
Reach, weight and the load chart
Every crane has a load chart that shows how much it can safely lift at each radius and boom configuration. As the radius grows, the safe working load falls. A crane that lifts five tonnes at three metres might manage less than half that at eight metres. The weight to use is the full weight of the set, including any fuel left in the base tank and the lifting accessories.
That is why we ask for the weight from the data plate or manufacturer's sheet and a measurement from where the vehicle can stand to where the generator must land. Guessing either number is the most common reason a lift has to be rebooked.
- Weight of the generator including fuel and accessories
- Horizontal distance from the crane to the landing point
- Height of obstacles such as walls, fences and roofs
- Space for the crane's outriggers to deploy fully
- Ground strength under the outrigger pads
Lift planning and the rules
The Lifting Operations and Lifting Equipment Regulations 1998 require every lift to be properly planned by a competent person, supervised appropriately and carried out safely, using equipment that is suitable and has been thoroughly examined. Lifting equipment must normally have a thorough examination at least every 12 months, and accessories such as slings and shackles at least every six months.
BS 7121, the British Standard code of practice for the safe use of cranes, sets out how lifts should be planned and managed, including the role of an appointed person who prepares the lift plan. Routine HIAB deliveries use a standard method statement; complex lifts get a specific plan.
Contract lift or crane hire
Mobile cranes are supplied in two main ways. Under a contract lift, the crane company plans and manages the lift and takes responsibility for it. Under crane hire, often called hired and operated, the crane and operator are supplied but the customer is responsible for planning and supervising the lift. Many customers do not realise the difference until something goes wrong.
For generator installations we arrange lifts so planning responsibility is clear and sits with a competent party. If you are booking a crane yourself, confirm in writing which arrangement applies.
Site checks that affect the choice
Look up before booking. Overhead power lines near the lift area are a serious hazard, and lifts close to them need careful planning and sometimes the network operator's advice. Look down too: cellars, drains, manholes and soft verges may not take outrigger loads, and ground mats or spreader pads may be needed.
On public roads, a lift that oversails the pavement or blocks a lane may need permission from the highway authority. Send photographs of the area and the route in, and we will confirm the right method before quoting.
Cost comparison in practice
A HIAB delivery is one vehicle doing two jobs, which is why it is cheaper. A mobile crane lift means paying for haulage and a crane, plus the crane's travel time to site, rigging, the lift itself and de-rigging. On a short job the crane may be on site for only an hour or two, but you pay for a minimum period.
Sometimes a slightly different landing point makes a HIAB workable. Moving the plinth a few metres closer to the road, or removing a section of fence for the day, can save the cost of a mobile crane entirely. It is worth asking that question before the base is built, because once the concrete is poured the position is fixed and so is the lifting method.
Questions people also ask
What size generator can a HIAB lift?
It depends on the crane fitted and the reach needed. Larger lorry-loader cranes routinely place canopied sets in the 200–500kVA range on open sites. The key figure is capacity at the required radius, so the weight of the set and the distance to the landing point decide whether a HIAB is enough.
Do I need a lift plan for a generator delivery?
Yes. All lifting operations must be planned by a competent person under the Lifting Operations and Lifting Equipment Regulations 1998. Simple, repeatable HIAB deliveries are usually covered by a standard plan and method statement, while complex crane lifts need a specific plan prepared after a site survey.
Can a crane lift a generator onto a roof?
Yes, a mobile crane can place a generator on a roof, provided the roof structure is strong enough for the set and its base. A structural engineer should confirm that first. The crane size depends on the weight, the height and how far the landing point is from where the crane can stand.
Written and checked by the Generator Transport team. Read our editorial policy.
More guides
How Much Does Generator Transport Cost in the UK?
Generator transport in the UK costs £120–£280 locally for a portable set up to 60kVA, £350–£700 for a 60–200kVA canopied set moved by HIAB and…
Preparing Your Site for a Generator Delivery: Checklist
Before a generator delivery, confirm the lorry can reach a firm, level parking spot close to the drop point, clear the landing area, check for…
Standby Generator Installation Moves: What Happens
A standby generator installation move starts with a site survey and a lift and rigging plan. The old set is disconnected by an electrician, drained…
Transporting Generators: Fuel, Load Securing and Safety Rules
When generators are moved by road, diesel in the base tank is a dangerous good under ADR, so fuel levels and tank security must be managed. Sets must…
Get a free generator transport quote
Tell us what you need and we'll come back with a clear price.
Request a quote